Foire Aux Questions Questions fréquemment posées au sujet de nos produits et de nos solutions

Question Question

Toute la FAQ (sur un total de 1872: affichage de 561-580)

Can the A205 be used to determine signal strength (RSSI) of a wireless sensor?
To use the A205 with a wireless sensor interface and a wireless sensor base, is direct line of sight necessary?
Quel type de brise vent peut-on utiliser pour un pluviomètre à auget basculant ?
If a phone line is shared with a seismograph that transmits data when it is called from a computer, is it possible to avoid interference by having the COM220 call out rather than transmit after receiving an outside call?
Why would installing a COM220 on a datalogger disrupt the connection to a met station?
Can a COM220 be used to connect to a remote DCP using RS-232 through a cellular telephone?
Is there a way to remotely change the number of rings from two to four on the COM220?
What type of cable is compatible with the COM220 and can be used for a 2 km distance?
Can a COM220 and a spread-spectrum radio coexist on the CS I/O port of a PakBus datalogger?
What is involved to install the COM220?
Is it possible to use a COM220 with a datalogger to send text messages to a GSM phone?
Is it possible to make an SMS (short message service) with the COM220?
Can a COM220 be used to activate a solid-state power switch?
Can a VoIP (voice over Internet protocol) phone line be used to call a COM220?
What is needed to download data remotely using a COM220?
Are CS I/O communications possible with the COM220?
Other than by using the CRBasic Editor or Edlog, is there a way to remove the Default sensor and its measurements (for example, BattV, PTemp_C, and ProgSig) from SCWin?
Que fait SCWin ou Short Cut ?
Existe-t-il un moyen simple de programmer une centrale de mesure ?
Quelle sont les spécifications du câble d'extension du CS220-L ?

Précédent Suivant