Foire Aux Questions Questions fréquemment posées au sujet de nos produits et de nos solutions

Question Question

Toute la FAQ (sur un total de 1878: affichage de 1741-1760)

Si je télécharge des données sur mon PC, le fichier résultant "CR1000_Table1.dat" est, par exemple, d’une taille de 150Kb. 150Kb est-elle la taille nécessairement sur la CR1000? Y a-t-il un type de compression de données utilisé ?
Peut-on communiquer en TCP/IP avec une CR1000 ?
La CR1000 peut-elle gérer des alarmes ?
Puis-je mesurer un signal 4-20mA sur une CR1000 ?
Can I use the digital camera with my RF network and transmit the images back to the office using Loggernet?
I am trying to set up a CC640 with a CR10x (not the 2M variety) to send images via a freewave radio. I'm wondering if I need loggernet 3 (I have 2) or if I just need the lvcmd.exe file to view these pics through the logger?
Quelle est la consommation en courant (mA) des moniteurs de vent 05103, 05305, 05103-45 et 05106 ?
The measurement instructions will likely remain the same but in addition to the multiplier and offset, the type of pulse may change for the wind speed and the excitation voltage may change for the wind direction. The manual easily explains how the logger needs to be programmed.
If I replace an existing wind set with the wind monitor, will I have to change more than the multiplier and offset in the datalogger program?
What is the procedure for orienting a WindSonic-L to the cardinal directions, so that the wind direction readings are correct?
I'm trying to interface with a 21X (s/n 3329) with an IBM thinkpad, using an SC32B connected to a radioshack RS-232 to USB adapeor. This connection has worked with two CR10X dataloggers and a CR10 datalogger. However, it does not work with the 21X. Do you have any suggestions?
Can I install the 21X Micrologger to capture soil water?
Peut-on échantillonner les données sur une CR5000 à 1000 Hertz ?
When I dial up to the unit I can see the barometric pressure data in real time. When I attempt to collect data from the unit via dial up or even via storage module, the barometric data are all 0's.
How do you transfer data from the 21X to Storage Module?
Which battery packs are recommended for use with the 21X datalogger?
I am looking for information on the 21X datalogger. Removal of the expansion memory module to be specific . I was trained on the CR10X in Edm, but have no info on the 21X.
Est-ce que le 03101 est capable de délivrer une sortie carré 0-5VCC de la vitesse du vent ?
Do heater resistance values of 37 to 48 ohm indicate a problem with the 229-L, or are those values within the normal range?
Quelle est la limite de la taille mémoire d'une carte sur une CR5000 ?

Précédent Suivant