Toggle navigation
Produits
Solutions
Support
À propos
Accueil
Produits
Solutions
Support
À propos
Demande de devis
Contact
Sites Web dans le monde
Sites Web dans le monde
Africa
Australia
Brasil
Canada
Centro Caribe
Deutschland
España
Europe
France
India
Japan
United States
ภาษาไทย
中国
Répertoire des pays
Connexion
Foire Aux Questions
Questions fréquemment posées au sujet de nos produits et de nos solutions
Question
Question
Recherche
Toute la FAQ
(sur un total de 1872: affichage de 1761-1780)
How many data lines can a SM192 and a SM4M store using a simple program?
1.Is there software that will allow the connection of SM4M to a laptop through a USB port since laptops do not often have a 9-pin com port?
1.Is there software that will allow the connection of SM4M to a laptop through a USB port since laptops do not often have a 9-pin com port?
If a version of PC208 will not recognize a SM4M, is there a download that can be used to retrieve the data?
I am looking for a net radiation and a solar radiation sensor for Idaho to be deployed during the summer and winter. Would the CNR1 be a good choice? I don't know if I will have enough power to use the heater consistently.
How often is recalibration recommended for the CNR1?
How high above the ground should a net radiometer be placed?
What kind of a regulator would you recommend if I want to set up a manually-powered generator to charge a 12-V gel battery? I have access to a 24 volt generator, but would that be too much do you think?
I have the CH12R (12V charger/regulator). I am trying to connect it to a 17.5-V, 290-mA, 5.1-W solar panel, to keep a 12-V battery charged. I just wanted to know how to go about doing this.
How many solar panels can be connected to a CH100 regulator? Can one 60 W solar panel and two 20 W solar panels be connected to the same regulator?
What might cause a PS100 or CH100 to fail after less than a year?
I have a PS100 with a charging regulator inside my enclosure. I would like to charge it with 110 V ac power at my site. I want to run my 110-V power cable directly into the enclosure, and not use a wall-mount style transformer/charger. Do you sell an ac transformer that will go inside my enclosure or should I buy one locally? Also, what is the preferred transformer voltage for the PS100?
Can an NL100 be set up through DevConfig using a 17394 cable instead of an RS-232 null modem cable? Would a 17394 connected to an SC32B be basically the same as an SC-USB?
Pourriez-vous me dire à quoi correspond la connexion des broches de la DB9 (RS232) avec le connecteur USB ?
Can a USB-to-9-Pin Male RS-232 Cable (pn 17394) be used between a laptop and a CR10 datalogger, which has a storage module (SM192)?
I recently bought a laptop to replace an older laptop we used to communicate with four 21X Microloggers®. I discovered the new laptop did not have an RS-232 DB-9 port, but it does have two USB ports. I understand that the CS I/O port on the 21X is not standard RS-232 protocol. Will the 17394 cable work with the 21X or do you have another cable that will? Or do I need to do something else?
I'm looking for a wind monitor (speed and direction) that could be used with a tethered balloon system. The main feature I'm concerned with (aside from weight) is a built-in datalogger. Would you have anything that would meet this requirement or do all your systems require direct wiring to a separate datalogger.
Puis-je utiliser le moniteur de vent sans centrale de mesure ?
Si je remplace un capteur de vent existant par un moniteur du vent ,vais-je devoir changer le multiplicateur et l'offset dans le programme de la centrale de mesure ?
We have an R.M. Young marine anemometer with a cable that is about 13 ft long. We would like to extend the cable another 20 ft or so. Do you sell a separate extension cable for the anemometer?
Précédent
Suivant